If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have the heat sink mounted to the stock arm and then the housing was gutted and wrapped around the heatsink to give it the original look with the addition of two tiny fans mounted on top.
Original switch was removed to give it a "flow through" design with the housing.
Are these similar to a porcelain crab? I had a porcelain crab one time a while back that would do this. Well I was lead to believe it was a p crab anyways...
Are these similar to a porcelain crab? I had a porcelain crab one time a while back that would do this. Well I was lead to believe it was a p crab anyways...
Oh ok, i had a blue one. I like the one you got better...
Seen a blue one too but I had to pick just one since I've only got one rbta for it to be hosted by. Might just cut my rbta in half and go get the other one.
Comment