Announcement

Collapse
No announcement yet.

Buffer to raise ph

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • tito206
    replied
    Originally posted by morpheus View Post
    your pH could very well be lower than 7.4 since thats the lowest reading for the high range pH test. i am going off the master liquid test kits you see in LFS. a full point over the course of 4 to 7 days is quite a swing. try getting a regular pH test reading too and see if its even lower.

    limestone and holey rock will raise the pH and KH of the water. not sure about GH. the limestone emits calcium carbonate into the water to buffer it more naturally over time. it will usually only result in a few decimal point increase, but will keep it at that level more consistently. the rock can do more depending on the chemistry of the water.

    i found this article helpful in the past:
    Suitability of Rocks in the Aquarium - A Practical Guide by Bob Wyllie Most rocks that you find in your yard, in creeks or streams, or elsewhere in nature pose no problems for use in the aquarium. Those few that may cause problems can be identified by applying a few simple procedures or...


    i use baking soda in a pinch if i see the pH is low, but it will only be a temporary fix and you would need to keep monitoring it. small doses as needed. add it carefully as it will swing the pH quickly if you use too much. the pH will settle again so going back and forth in pH can stress the fish.
    its 7.6 on the low end and 7.4 on the high end

    Sent from my SM-N900V using Tapatalk

    Leave a comment:


  • morpheus
    replied
    your pH could very well be lower than 7.4 since thats the lowest reading for the high range pH test. i am going off the master liquid test kits you see in LFS. a full point over the course of 4 to 7 days is quite a swing. try getting a regular pH test reading too and see if its even lower.

    limestone and holey rock will raise the pH and KH of the water. not sure about GH. the limestone emits calcium carbonate into the water to buffer it more naturally over time. it will usually only result in a few decimal point increase, but will keep it at that level more consistently. the rock can do more depending on the chemistry of the water.

    i found this article helpful in the past:
    Suitability of Rocks in the Aquarium - A Practical Guide by Bob Wyllie Most rocks that you find in your yard, in creeks or streams, or elsewhere in nature pose no problems for use in the aquarium. Those few that may cause problems can be identified by applying a few simple procedures or...


    i use baking soda in a pinch if i see the pH is low, but it will only be a temporary fix and you would need to keep monitoring it. small doses as needed. add it carefully as it will swing the pH quickly if you use too much. the pH will settle again so going back and forth in pH can stress the fish.
    Last edited by morpheus; 04-21-2014, 08:37 AM.

    Leave a comment:


  • tito206
    replied
    Originally posted by LordBarron7692 View Post
    I'm pretty sure limestone will not sure about holey rock though
    Ok thanks

    Sent from my SM-N900V using Tapatalk

    Leave a comment:


  • LordBarron7692
    replied
    I'm pretty sure limestone will not sure about holey rock though

    Leave a comment:


  • tito206
    replied
    Originally posted by LordBarron7692 View Post
    ahh ok yeah you're probably gonna want to try using baking soda or get like a 55 gal drum and put either limestone or crush coral in it and use that as you change water cause I don't think the buffer will be a long term fix for you
    Ok thanks would limestone or holey rocks raise the gh and kh too?

    Sent from my SM-N900V using Tapatalk

    Leave a comment:


  • LordBarron7692
    replied
    ahh ok yeah you're probably gonna want to try using baking soda or get like a 55 gal drum and put either limestone or crush coral in it and use that as you change water cause I don't think the buffer will be a long term fix for you

    Leave a comment:


  • tito206
    replied
    Originally posted by LordBarron7692 View Post
    do you use a water softener for the house or are you on well water? most city of Houston water is gonna be around 8.0 or so.
    I'm on well water it comes out of tap at 7.6

    Sent from my SM-N900V using Tapatalk

    Leave a comment:


  • LordBarron7692
    replied
    do you use a water softener for the house or are you on well water? most city of Houston water is gonna be around 8.0 or so.

    Leave a comment:


  • tito206
    replied
    Originally posted by LordBarron7692 View Post
    wow ok so what is it before a water change.
    It is at 8.4

    Sent from my SM-N900V using Tapatalk

    Leave a comment:


  • LordBarron7692
    replied
    wow ok so what is it before a water change.

    Leave a comment:


  • tito206
    replied
    Originally posted by LordBarron7692 View Post
    what size tank is it? Have you taken a ph reading on the tank after a water change?
    It's a 90 gallon tank and yes I have done a ph reading on the tank after a pwc it reads 7.4 on the high range

    Sent from my SM-N900V using Tapatalk

    Leave a comment:


  • LordBarron7692
    replied
    what size tank is it? Have you taken a ph reading on the tank after a water change?

    Leave a comment:


  • tito206
    replied
    Originally posted by LordBarron7692 View Post
    well how have the fish been reacting to water changes, and how often do you do a water change?
    They swim away fast and hide I do a 25 to 30% water change like every 4 to 7 days cause I'm trying to bring my nitrates down

    Sent from my SM-N900V using Tapatalk

    Leave a comment:


  • LordBarron7692
    replied
    well how have the fish been reacting to water changes, and how often do you do a water change?

    Leave a comment:


  • morpheus
    replied
    personally i dont really chase the perfect pH. a stable pH is more important.

    mbunas adapt very well to many different pH levels. my tap is 8.0 as well, but the pH does settle a little below that over time. my mbunas still do great. i did add some larger chunks of limestone/coral rock too just to keep it elevated. i also have large pieces of driftwood, which can lower my pH so the rocks offset it. i think i am around that 7.6 range.

    adding buffers may or may not work. it depends on your hardness (KH). if you have hard water, like most of houston, it will resist pH change and settle in its own zone over time no matter how much buffer you add.

    Leave a comment:

Working...
X